Install Instructions:
STEP 1 | Compress installed spring and insert tool* into the cross hole to hold the spring down.
STEP 2 | Remove the dovetailed end cap. Then remove the tool from the cross hole, allowing the spring to be removed.
STEP 3 | Install a different spring weight, compress new spring, and insert the tool back into the cross hole again.
STEP 4 | Align dovetail to install cap, remove the tool, and allow spring to capture around the dovetail interface.
While a tool is not necessary for the Radian guide rod, it can assist in holding the spring down when removing and installing the cap.
